Gas Leak Detection Glendale
Gas leak detection in Glendale means finding the escape with gas detectors, a pressure test and a pipe locator, then repairing it, usually on that visit. Your plumber in Glendale quotes the repair before any pipe is opened. If you can smell gas inside, clear the house before you ring (02) 4063 3469.
Licensed plumbers and gas fitters · NSW Lic. 359278C
Last updated September 2026
First Steps When You Smell Gas
Safety comes before any plumbing talk.
- Walk everyone, pets too, out through the nearest door and leave it open.
- Leave lights, appliances and power points exactly as they are, since a spark is the risk.
- From the footpath or the yard, ring the emergency number for your gas network on your mobile.
- When the network has cleared the site, call (02) 4063 3469 to have the leak on your side found and fixed.
What Are the Signs a Line Is Leaking?
Some leaks announce themselves and some hide. Watch for:
- A rotten-egg smell (the odorant added to gas) around the stove, a heater or the meter box
- A burner flame that has turned lazy and yellow
- A hiss you can hear at a fitting or at the meter
- Headaches, nausea or dizziness indoors that clear up once you step outside
Any of these is reason to get the line tested.
How Do We Trace and Repair the Leak?
- 01
Isolate
The meter valve is closed so no gas reaches the fault during the work.
- 02
Trace
Gas detectors are run along the line and over every joint, and the pipe locator maps where the run goes under floors or ground.
- 03
Confirm
A pressure test on the line proves where the escape sits and rules out the sections that hold.
- 04
Repair
The faulty joint or section is fixed or replaced, then the repaired line holds pressure again before the stove or heater is relit.
What Drives the Price of a Leak Repair?
We provide up-front, honest quotes that will always match the final price, should you decide to go ahead.
It starts with how hard the leak is to find:
- Trace length, since a joint beside the meter is quicker to reach than one under the back bedroom
- Pipe type, as copper, galvanised and polyethylene lines are each repaired a different way
- Whether a joint can be remade or a whole section needs replacing
- Whether the job lands inside normal hours or after hours
Related gas work. The gas fitting hub covers the full range, from a cooktop or heater connection to a full line repair. A leak that has cut the hot water off as well is sorted through our hot water work, and night-time faults of every kind sit with our emergency plumber service.
Where the Old Gas Lines Run Around Here
The older cottages hide the longest gas runs
Later homes, different pipe
What Customers Say
We had an urgent gas problem that required immediate attention at our home…on a Friday afternoon. … Identified the issue, fixed and tested
When We're Not the Right Call
A leak on the street side of the meter, in the main or the service pipe feeding it, is the gas network's repair, so the emergency number you rang first is the one that fixes it. An oven or heater with a failed control board goes back to its maker's service agent.
What Happens After You Ring
- 01
Ring or send the form
Call (02) 4063 3469 or use the form to explain the fault. We ask enough to bring the right equipment the first time.
- 02
A fixed price first
A plumber inspects the job and names a fixed figure up front. Nothing gets started until you give the go-ahead.
- 03
The trace and the fix
Gas detectors and a pressure test find the escape, the repair is made, and the line is re-tested before anything gets relit.
- 04
Covered for a year
Every job carries our 365-day warranty on all work. If something we did isn't right, ring the same number.
Questions People Ask About Gas Leaks
Do you come out to Glendale homes after hours for a gas smell?
Yes, any night of the week. Move everyone clear of the house first, then ring (02) 4063 3469 and say what you can smell and where it is strongest.
Is finding and fixing a gas leak a licensed job?
It is. Gas work in NSW sits with licensed gas fitters, and every trace, repair and pressure test we carry out is done under that licence. The same licence covers relighting and checking your appliances once the line holds pressure again.
Can you check the gas line feeding an old heater in a Glendale cottage?
Yes. Many older cottages here still run their original copper or galvanised feed under the floor, and a pressure test shows whether the line to a heater or stove still holds. If it does not, the repair is quoted before anyone touches it.
Do you repair the leak or only find it?
Both. Once the escape is found, a loose joint is usually remade on that visit. A corroded section that cannot hold is quoted as a replacement run, and the work waits for your go-ahead.
Need a plumber? Call or send the form
Call (02) 4063 3469 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.
Request a callback
Leave a name and number and a plumber will ring you back.